System Setup
9 - 256
9.26.4 Safety logic circuit
1. Display of the window.
Select {SAFETY LOGIC CIRCUIT} from {SAFETY FUNC.} in the main menu.
2. Create the safety logic circuit
Create the safety logic circuit. The setting items are “INPUT1”, “LOGIC”, “INPUT2” and
“OUTPUT”. Set “TIMER” and “COMMENT” if necessary.
The INPUT1 and INPUT2 must be set.
When setting the input 1 or 2, LOGIC is also must to be set.
OUTPUT is also must be set. The same output signal cannot be set to the multiple logic
circuit.
After creating the safety logic circuit, the status changes from “DONE” to “NOT DONE”.
The “WRITE” button is shown on the left down corner of the screen.
3. Canceling the edit
To start over the editing, select {CANCEL EDIT} from {EDIT} in the pull-down menu.
4. Line clear
To clear the one line, select {LINE CLEAR} from {EDIT} in the pull-down menu.
To Next Page
Loading...
