Programming pendant
12 - 360
12.3 Touch panel invalidate function
The touch panel invalidate function enables to invalidate the touch panel operation of the
programming pendant (key operation is still valid).
Even if the touch panel is failure, it is able to prevent the mis-operation by using this
function.
Operate the following procedures to valid/invalid the touch panel.
• Invalidate the Touch Panel
1. Push down the [INTER LOCK]+[AUX] keys at the same time.
The confirmation dialog to invalidate the touch panel appears.
2. Move the focus area over the “YES” on the confirmation dialog by using [] key.
3. Press [Select] key. The touch panel becomes invalid.
When the touch panel is invalid, an icon, which shows the invalidating the touch panel,
is displayed on the status area, and the message “Touch operation is invalid” is
displayed on the message area.
• Validate the Touch Panel
1. Push down the [INTER LOCK]+[AUX] keys at the same time.
The confirmation dialog to validate the touch panel appears.
2. Move the focus area over the “YES” on the confirmation dialog by using [] key.
3. Press [Select].
The touch panel become valid.
NOTICE
In the case of invalidating the touch panel, the touch panel invalidating status continues
even though the power supply is turned ON/OFF.
To validate the touch panel again, push down the [INTER LOCK]+[AUX] keys at the
same time, and then validate the touch panel on the confirmation dialog.
To Next Page
Loading...
