Programming pendant
12 - 361
12.4 Reboot robot system
After change a parameter, repair or maintenance, following procedure to reboot the robot
system.
The robot system cannot be rebooted when the servo power is ON. Confirm that the servo
power is OFF before rebooting.
1. Select {SYSTEM INFO} - {CPU RESET} in the main menu.
2. Confirm the SERVO power is OFF and select {RESET}.
3. The confirmation dialog appears.
Select {YES} to reboot the robot system.
4. If the operation to reboot the robot system is performed when the SERVO power is ON,
the following error message appears.
Select “CANCEL” to cancel the error message.
To Next Page
Loading...
