Modification of System Configuration
13 - 370
13.3.1 Base Axis Setting
13.3.1.1 Selection of Base Axis Type
Select the type of base axis to be added/modified.
1. Turn the power supply ON while pressing [Main Menu] simultaneously.
2. The SECURITY mode is changed to the MANAGEMENT mode.
3. Select {SYSTEM} from the main menu.
– The system window appears.
4. Select {SETUP}.
– The SETUP window appears.
– Please note that the points marked with "" cannot be selected.
5. Select {CONTROL GROUP}.
– The current control group type is displayed.
To Next Page
Loading...
