System Setup
9 - 82
9.1.3 Changing the absolute data
To change the absolute data of the axis when home position calibration is completed,
perform the following:
1. Select {ROBOT} from the main menu.
2. Select {HOME POSITION}.
3. Select the desired control group.
Perform steps 3 and 4 which have been described in chapter “Registering All Axes at
One Time” to select the desired control group.
4. Select the absolute data to be registered.
The number can now be entered.
5. Enter the absolute data using the numeric keys.
6. Select {ENTER}.
Absolute data are modified.
9.1.4 Clearing absolute data
1. Select {ROBOT} from the main menu.
2. Select {HOME POSITION}.
Perform steps 2, 3, and 4 which have been described in “Registering All Axes at One
Time” to display the HOME POSITIONING window and select the desired control
group.
3. Select {DATA} under the menu.
The pull-down menu appears.
To Next Page
Loading...
