EasyManua.ls Logo

YASKAWA NX100 - Page 129

YASKAWA NX100
247 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
8.3 Alarm Message List
8-25
1220
LAN COMMUNI-
CATION PARAM-
ETER ERROR
75 Incorrect setting of the domain
which is used in the Ethernet func-
tion.
Set the correct domain.
1221
ETHERNET
RESET ERROR
1 An error occurred in the device ini-
tialization process of the Ethernet
function.
• Turn the power OFF then back ON.
If the error occurs again, contact your
Yaskawa representative.
2 An error occurred in the IP address
setting process of the Ethernet
function.
3 An error occurred in the subnet
mask setting process of the Ether-
net function.
4 An error occurred in the default
gateway setting process of the
Ehternet function.
5 An error occurred in the host name
setting process of the Ehternet
function.
6 An error occurred in the MAC
address acquisition process of the
Ehternet function.
20 An error occurred in the Web server
task creating process of the Ehter-
net function.
21 An error occurred in the FTP server
task creating process of the Ehter-
net function.
22 An error occurred in the FTP client
task creating process of the Ehter-
net function.
30 An error occurred in the semaphore
generation process for access
exclusion of the Ethernet function.
50 An error occurred in the Web server
task management ID getting pro-
cess of the Ehternet function.
51 An error occurred in the FTP server
task management ID getting pro-
cess of the Ehternet function.
59 An error occurred in the DHCP
acquisition item setting process of
the Ethernet function.
60 An error occurred in the DHCP ini-
tialization process of the Ethernet
function.
61 An error occurred in the DHCP
interface of the Ethernet function.
1221
ETHERNET
RESET ERROR
62 The data acquisition process from
the server did not complete within
regulated time.
Verify the DHCP server operation and the
network status.
63 The data acquired from the server
were found illegal in the DHCP of
the Ethernet function.
64 An error occurred in the subnet
mask acquisition process in the
DHCP of the Ethernet function.
Alarm Message List
Alarm
Number
Message
Sub
Code
Cause Remedy

Table of Contents

Other manuals for YASKAWA NX100

Related product manuals