YASKAWA NX100 - Page 130

8.3 Alarm Message List
8-26
1221
ETHERNET
RESET ERROR
65 An error occurred in the DNS
server address acquisition process
in the DHCP of the Ethernet func-
tion.
• Verify the DHCP server operation and the
network status.
66 An error occurred in the Ethernet
function DNS domain acquisition
process in the DHCP of the Ether-
net function.
67 An error occurred in the SNTP
server address acquisition process
in the DHCP of the Ethernet func-
tion.
68 An error occurred in the IP address
acquisition process in the DHCP of
the Ethernet function.
69 An error occurred in the DHCP
Interface structure mapping pro-
cess of the Ethernet function.
• Turn the power OFF then back ON.
If the error occurs again, contact your
Yaskawa representative.
70 An error occurred in the DNS
resolver initialization process of the
Ethernet function.
71 An error occurred in the DNS
resolver setting of the Ethernet
function.
• Verify the domain name and the DNS-
related settings.
• When the DHCP is used, verify the DHCP
server operation and the network status.
72 The parameter setting error
occurred in the DNS resolver set-
ting of the Ethernet function.
73 The mode error occurred in the
DNS resolver setting of the Ether-
net function.
• Verify the domain name and the DNS-
related settings.
• When the DHCP is used, verify the DHCP
server operation and the network status.
80 An error occurred in the basic
library initialization process of the
Ethernet function.
• Turn the power OFF then back ON.
If the error occurs again, contact your
Yaskawa representative.
81 An error occurred in the initializa-
tion process other than basic library
of the Ethernet function.
100 An error occurred in the IP address
acquisition process in the DHCP of
the Ethernet function.
240 An error occurred in the start pro-
cess of the Ethernet function Telnet
(for onboard).
241 An error occurred in the start pro-
cess of the Ethernet function Telnet
(for expand).
1222 IP ADDRESS
SET FAIL(DHCP)
---- The IP address acquired by the
DHCP of Ethernet function is
invalid.
• Verify the DHCP server oparation and the
network status.
1223 PLD MONITOR1
ERROR (HIF01)
0000_
00
∗∗
The watchdog timer circuit which
checks the safety circuit is dam-
aged.
0000_0001: 1 signal (PLD1) error
0000_0010: 2 signal (PLD2) error
• Replace the NIF circuit board.
1224 PLD MONITOR2
ERROR (HIF01)
0000_
00
∗∗
An error occurred in the watchdog
timer which checks the safety cir-
cuit.
• Turn the power OFF then back ON.
If the error occurs again, replace the NIF unit.
Alarm Message List
Alarm
Number
Message
Sub
Code
Cause Remedy