YASKAWA SGD7S - Page 589

14.1 List of Parameters
14.1.2 List of Parameters
14
Parameter Lists
14-25
Pn50C
2
Input Signal Selections
3
0000 to
FFFF
− 8888 All
After
restart
Setup –
Continued on next page.
Continued from previous page.
Parameter
No.
Size
Name
Setting
Range
Setting
Unit
Default
Setting
Applicable
Motors
When
Enabled
Classi-
fication
Refer-
ence
n.X
/SPD-D (Motor Direction) Signal Allocation Reference
0 Active when CN1-40 input signal is ON (closed).
page 6-53
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7 The signal is always active.
8 The signal is always inactive.
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
n.X
/SPD-A (Internal Set Speed Selection Input) Signal Allocation Reference
0 to F
The allocations are the same as the /SPD-D (Motor Direction) sig-
nal allocations.
page 6-53
n.X
/SPD-B (Internal Set Speed Selection Input) Signal Allocation Reference
0 to F
The allocations are the same as the /SPD-D (Motor Direction) sig-
nal allocations.
page 6-53
n.X
/C-SEL (Control Selection Input) Signal Allocation Reference
0 to F
The allocations are the same as the /SPD-D (Motor Direction) sig-
nal allocations.
page 6-57