7. Click the Start Button.
Fig. 230: Tuning - Reference Transmission Dialog Box
ð
1 - Start Button
The reference conditions will be transferred to the SERVOPACK. A progress
bar will show the progress of the transfer.
2 - Cancel Button
The Cancel Button is enabled only while data is being transferred to the SER-
VOPACK.
You cannot use it after the transfer has been completed.
3 - Back Button
This button returns you to the Condition Setting Dialog Box. It is disabled while
data is being transferred.
4 - Next Button
This button is enabled only when the data has been transferred correctly. You
cannot use it if an error occurs or if you cancel the transfer before it is com-
pleted.
Click the Next Button to display the Operation/Measurement Dialog Box.
5 - Cancel Button
This button cancels processing and returns you to the Tuning Dialog Box.
8. Click the Next Button.
ð
The Operation/Measurement Dialog Box will be displayed.
Sigma-7 Series SERVOPACKs
Tuning
Estimating the Moment of Inertia > Operating Procedure
| | PROFINET Communications - SIEP YEUOC7P 02A Revision 0 | en | 316
To Next Page
Loading...
