YASKAWA VIPA SPEED7 - Page 127

Byte Parameter Data type Start value Description
34 ... 39 rem_staddr ARRAY
[1..6] of
BYTE
00h ... IP address for the remote connection transmission
point: e.g. 192.168.002.003: With connection_type
n TCP / ISO on TCP
– rem_staddr[1] = C0h (192)
– rem_staddr[2] = A8h (168)
– rem_staddr[3] = 02h (002)
– rem_staddr[4] = 03h (003)
– rem_staddr[5-6] = irrelevant
n UDP
– This parameter is not used. Assign param-
eter to 00h.
n TCP (Comp.)
– rem_staddr[1] = 03h (003)
– rem_staddr[2] = 02h (002)
– rem_staddr[3] = A8h (168)
– rem_staddr[4] = C0h (192)
– rem_staddr[5-6] = irrelevant
40 ... 55 rem_tsap_id ARRAY
[1..16] of
BYTE
00h ... With connection_type
n TCP: remote port number (possible values:
2000 ... 5000)
– rem_tsap_id[1] = high byte of port no in
hexadecimal representation
– rem_tsap_id[2] = low byte of port no in
hexadecimal representation
– rem_tsap_id[3-16] = 00h
n ISO on TCP: remote TSAP-ID:
– rem_tsap_id[1] = E0h (connection type T-
connection)
– rem_tsap_id[2] = Rack and slot for the
remote connection transmission point
CPU (bits 0 ... 4: slot, bits 5 ... 7: rack
number),
– rem_tsap_id[3-16] = TSAP extension
n UDP
This parameter is not used. Assign parameter
to 00h
n 01h: remote port number (possible values:
2000 ... 5000)
– local_tsap_id[1] = low byte of port number
in hexadecimal representation
– local_tsap_id[2] = high byte of port
number in hexadecimal representation
– local_tsap_id[3-16] = 00h
56 ... 61 next_staddr ARRAY
[1..6] of
BYTE
00h ... Rack and slot of the configured CP for the PG/OP
interface
n 00h (Ethernet P/OP channel)
– next_staddr[1]: 04h
– next_staddr[2-6]: 00h
n 02h (Ethernet CP)
– next_staddr[1-6]: 00h
VIPA SPEED7
Network Communication
Open Communication > UDT 65 - TCON_PAR Data structure for FB 65
HB00 | OPL_SP7 | Operation list | en | 18-30 127