13.4.3 Wiring
13.4.3.1 Connecting the V1000 inputs
The following figure shows an example application for connecting the inputs of a V1000
inverter drive via PWM to a System MICRO CPU M13C. In this example the PWM
channel 0 (X2 - pin 8) is connected. Please use X2 - pin 7 to connect to channel 1.
R Resistor
Value: max. 470Ω
Power dissipation: min. 0.6W
Resistance example: Metal film resistor 0207 wired with 0.6W power dissipation
Cable length max. 20m
Sample application
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via PWM > Wiring
HB00 | OPL_SP7 | Operation list | en | 18-30 432
To Next Page
Loading...
