9. Navigate in the hardware catalog to the directory ‘PROFINET IO
è Additional field devices è I/O è VIPA ...’ and connect e.g. for the System
MICRO the IO device ‘M13-CCF0000’ to your PROFINET system.
ð
In the Device overview of the PROFINET IO device ‘VIPA MICRO PLC’ the
CPU is already placed at slot 0.
1. Place for the Ethernet PG/OP channel at slot 4 the Siemens CP 343-1 (SIMATIC
300 \ CP 300 \ Industrial Ethernet \CP 343-1 \ 6GK7 343-1EX30 0XE0 V3.0).
2. Open the properties dialog by clicking on the CP 343-1EX30 and enter for the CP at
‘Properties’ the IP address data. You get valid IP address parameters from your
system administrator.
3. Assign the CP to a ‘Subnet’ . The IP address data are not accepted without assign-
ment!
A hardware configuration to enable the PtP functionality is not necessary.
1. Turn off the power supply.
2. Mount the extension module.
3. Establish a cable connection to the communication partner.
4. Switch on the power supply.
ð
After a short boot time the interface X1 PtP is ready for PtP communication.
Configuration of Ethernet
PG/OP channel
Enable PtP functionality
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via Modbus RTU > Usage in Siemens SIMATIC Manager
HB00 | OPL_SP7 | Operation list | en | 18-30 473
To Next Page
Loading...
