5. Select in the Network view the IO device ‘VIPA SLIO CPU’ and switch to the
Device overview.
ð
In the Device overview of the PROFINET IO device ‘VIPA SLIO CPU’ the CPU
is already placed at slot 0.
1. Open the properties dialog by a double-click at ‘VIPA SLIO CPU’ .
2. Select at ‘Function X3’ the value ‘PTP’ .
1. As Ethernet PG/OP channel place at slot 4 the Siemens CP 343-1 (6GK7
343-1EX30 0XE0 V3.0).
2. Open the "Property" dialog by clicking on the CP 343-1EX30 and enter for the CP at
"Properties" at "Ethernet address" the IP address data, which you have assigned
before. You get valid IP address parameters from your system administrator.
Enable PtP functionality
Configuration of Ethernet
PG/OP channel
VIPA SPEED7
Motion control - Simple Motion Control Library
Usage inverter drive via Modbus RTU > Usage in Siemens TIA Portal
HB00 | OPL_SP7 | Operation list | en | 18-30 491
To Next Page
Loading...
