YASKAWA VIPA SPEED7 - Page 792

STATUS[3] (Error ID) can have the following values:
Error_Decode Error_Code_1 Explanation according to
DP-V1
Description
A0h read error Negative acknowledgement while reading
the module.
A1h write error Negative acknowledgement while writing
the module.
A2h module failure DP protocol error at layer 2
A3h reserved, pass DP protocol error with Direct-Data-Link-
Mapper or User-Interface/User
A4h reserved, pass Bus communication disrupted
A5h reserved, pass -
A7h reserved, pass DP slave or module is occupied (tempo-
rary error)
A8h version conflict DP slave or module reports noncompat-
ible versions
A9h feature not supported Feature not supported by DP slave or
module
AA ... AFh user specific DP slave or module reports a manufac-
turer specific error in its application.
Please check the documentation from the
manufacturer of the DP slave or module.
B0h invalid index Record set not known in module
illegal record set number ≥256.
B1h write length error Wrong length specified in parameter
RECORD; with SFB 54: length error in
AINFO.
B2h invalid slot Configured slot not occupied.
B3h type conflict Actual module type not equal to specified
module type.
B4h invalid area DP slave or module reports access to an
invalid area.
B5h state conflict DP slave or module not ready
B6h access denied DP slave or module denies access
B7h invalid range DP slave or module reports an invalid
range for a parameter or value.
B8h invalid parameter DP slave or module reports an invalid
parameter.
B9h invalid type DP slave or module reports an invalid
type.
BAh ... BFh user specific DP slave or module reports a manufac-
turer specific error when accessing.
Please check the documentation from the
manufacturer of the DP slave or module.
C0h read constrain conflict The module has the record set, however,
there are no read data yet.
VIPA SPEED7
Integrated Standard
System Function Blocks > SFB 54 - RALRM - Receiving an interrupt from a periphery module
HB00 | OPL_SP7 | Operation list | en | 18-30 792