Record set SSL_ID: xy22h
INDEX
offset
Length Description
0 10words Start info for the given OB, with following exceptions:
n OB 1 provides the current minimum (in bytes 8 and 9) and maximum cycle time (in
bytes 10 and 11)
(time base: ms, byte count begins at 0).
n When a job is active for a time-delay interrupt, bytes 8 ... 11 (byte count begins at) get
the remaining time in ms left of the delay time set as a parameter.
n OB 80 contains the configured minimum (in bytes 8 and 9) and maximum cycle time
(in bytes 10 and 11)
(time base: ms, byte count begins at 0).
n Error interrupts without the current information.
n Interrupts contain the status info from the current parameter settings of the interrupt
source.
n In the case of synchronous errors, the priority class entered is 7Fh if the OBs were
not yet processed; otherwise, the priority class of the last call.
n If an OB has several start events and these have not yet occurred at the information
time, then event no. xyzzh is returned with:
x: event class
y: undefined
zz: smallest defined number in the group
Otherwise, the number of the last start event that occurred is used.
20 1word Processing identifiers:
n Bit 0: Interrupt event is caused by parameters:
– 0: enabled
– 1: disabled
n Bit 1: Interrupt event as per SFC 39 DIS_IRT
– 0: not locked
– 1: locked
n Bit 2: generation job ready for time interrupts, time-of-day/time-delay interrupt OB
started, cyclic interrupt OB was configured
– 0: Interrupt source is not active
– 1: Interrupt source is active
n Bit 3: reserved
n Bit 4: Interrupt OB
– 0: is not loaded
– 1: is loaded
n Bit 5: Interrupt OB is by TIS:
– 0: enabled
– 1: disabled
n Bit 6: Entry in diagnostic buffer
– 0: enabled
– 1: disabled
n Bit 15 ... 7: reserved
VIPA SPEED7
SSL System status list
Interrupt status - SSL-ID: xy22h
HB00 | OPL_SP7 | Operation list | en | 18-30 954
To Next Page
Loading...
