– The times must be specified in
µ
s
– The measurement of time starts with the first transition from Startup
to RUN.
SSL-ID: 05FAh
The data set contains the determined times for one execution cycle. This is the time
between the request and the full completion of the processing.
INDEX
offset
Length Value Description
0 1byte 05h Number of partial list: SSL Sub ID
1 1byte xxh OB Number: statistical information for OB xx
(INDEX see above)
2 1word xxxxh reserved
4 2words xxxxxxxxh Minimum execution time: The smallest measured time
8 2words xxxxxxxxh Maximum execution time: Maximum measured time
12 2words xxxxxxxxh Last run time: Last measured time
16 2words xxxxxxxxh Average execution time: The time is determined by the last 1000 recorded
times.
20 2words xxxxxxxxh Error counter: This counter is increased at the time, when the execution
cycle is longer than 60% of the projected Sync clock.
– The times must be specified in
µ
s
– The measurement of time starts with the first transition from Startup
to RUN.
– The cycle time of the Sync signal is set (HW configuration) via the
CPU properties.
Record set
VIPA SPEED7
SSL System status list
Statistics information to OBs - SSL-ID: xyFAh
HB00 | OPL_SP7 | Operation list | en | 18-30 999
To Next Page
Loading...
