YASKAWA YASNAC XRC - Changing a User ID; User ID

2.1 Protection Through Security Mode Settings
2-6
2.1.2
User ID
User ID is requested when Editing Mode or Management Mode is operated.
User ID must be between 4 characters and 8, and they must be numbers and symbols
(“0~9”,“-” and “.”).
"
Changing a User I
In order to change the user ID, the XRC must be in Editing Mode or Management Mode.
Higher security modes can make changes to lower security modes.
*1
User ID registration display is shown.
*2
The character input line is displayed, and the message "Input current ID no. (4 to 8
digits)” is displayed.
Select {SETUP} under the top menu Select {USER ID}
*1
Select the desired ID
*2
Input current ID and press [Enter]
*3
Input new ID and press [Enter]
*4
Operation
Explanation
USER ID
EDITING MODE
∗∗∗∗∗∗∗∗
MANAGEMENT MODE
∗∗∗∗∗∗∗∗
!Turn on servo power
R1
S
C
L
DATA
EDIT DISPLAY UTILITY
DATA
EDIT DISPLAY UTILITY
USER ID
EDITING MODE
∗∗∗∗∗∗∗∗
MANAGEMENT MODE
∗∗∗∗∗∗∗∗
>
!Input current ID no.(4 to 8 digits)
R1
SC
L