4.2 Addition of Base and Station Axis
4-13
When the data, for example motion range, must be changed after the addition of a
base axis or station axis, the change can be done with the same procedure shown
above.
In that case, the control group construction is not changed so the job file data should
not be initialized.
4.2.2
Station Axis Settin
*1
The control group display is shown.
If the control group construction is changed by addition a base axis or station axis, the
internal data of the job file are also changed so that the job file data should be initialized.
Initialize the job file data with the procedure “File Initialize” in this manual after changing
the construction.
Confirm the type of control group in control group display
*1
Select type of control
group for changing
*2
Select desired type in the type list
*3
Press [ENTER] in con-
trol group display
*4
CAUTION
Operation
Explanation
CONTROL GROUP
R1 :UP6-A0*
B1 :NONE
R2 :NONE
S1 :TURN-2
S2 :NONE
!Maintenance Mode
To Next Page
Loading...
