11.1 Error Message List
11-8
2300 -
Cannot teach JOB without group-axis
specification
2310
* Same label exists
XXX
2320 - Cannot create coordinated JOB Line No.
2330 - Cannot edit coordinated instruction Calibration not complete
2340 - Pasted data not found
2350 - Editing data not found
2360 - Cannot create editing area
2370 -
Cannot cut/copy NOP and EN
instructions
2380 - Wiring JOB selection
2390 - Wrong group axis selection
2400 - Cannot move in cut & paste editing
2410 -
When variable is used for speed set-
ting, perform a line-edit
2420 -
When variable is used for teach set-
ting, perform a line-edit
2430 - Reverse data not found
2440 - Move C-and W-axis to basic position Laser cutting
2450 - Relative JOB not permitted
2460 - Specified JOB is already converted
2470 - Wrong JOB type
2480 - Wrong JOB coordinates setting
2490 - Execute NEXT/BACK operation once
2500 - Cannot convert the JOB
2510 - Cannot correct position in the JOB
2520 - Enter JOB name
2530 - Illegal step number
2540 - Enter step number
2550 - Duplicated step number
2560 -
Cannot correct steps of position vari-
ables and REFP
Error No. Data Error Message Error Contents
To Next Page
Loading...
