1 Introduction
1.3 Definition of Terms Used Often in This Manual
1-5
159281-1CD
HW1480357
HP20D
1.3 Definition of Terms Used Often in This Manual
The MOTOMAN is the YASKAWA industrial robot product.
The MOTOMAN usually consists of the manipulator, the controller, the
programming pendant, and supply cables.
In this manual, the equipment is designated as follows:
1.4 Registered Trademark
In this manual, names of companies, corporations, or products are
trademarks, registered trademarks, or bland names for each company or
corporation. The indications of (R) and
TM
are omitted.
• Perform the following inspection procedures prior to conducting
manipulator teaching. If problems are found, repair them
immediately,
and be sure that all other necessary processing has been
performed.
– Check for problems in manipulator movement.
– Check for damage to insulation and sheathing of external wires.
• For the DX100, always return the programming pendant to the hook
on the cabinet of the DX100 after use.
For the FS100, always return the programming pendant to a safe
place after use.
The programming pendant can be damaged if it is left in the
manipulator's work area, on the floor, or near fixtures.
• Read and understand the Explanation of Warning Labels in the
DX100 Instructions before operating the manipulator:
Equipment Manual Designation
DX100 controller DX100
DX100 programming pendant Programming pendant
Cable between the manipulator and the
controller
Manipulator cable
To Next Page
Loading...
