4.2 Addition of Base and Station Axis
4-9
In the axes configuration display, the axis type and motor type are specified.
*1
The axis type of each axis is shown.
*2
The axis type which can be set is shown.
The traveling axis of ball-screw type should be selected as “BALL-SCREW,” the one of
rack & pinion type should be selected as “RACK & PINION.” Then the display returns to
the axes configuration display.
*3
The setting in the axes configuration display is completed and the display moves to the
mechanical specification display.
Confirm axis type of each axis in the axes configuration display
*1
Select desired
axis
*2
Select desired axis type Press [ENTER] in the axes configuration display
*3
Operation
Explanation
AXES CONFIG
B1 : RECT-XYZ
AXIS AXIS TYPE
1 : BALL-SCREW
2 : BALL-SCREW
3 : BALL-SCREW
!Maintenance Mode
AXES CONFIG
B1 : RECT-XYZ
AXIS AXIS TYPE
1 : BALL-SCREW
2 : BALL-SCREW
3 : BALL-SCREW
!Maintenance Mode
BALL-SCREW
RACK&PINION
BALL-SCREW
To Next Page
Loading...
