To Next PageTo Next PageWhy won't my Yazoo/Kees KHKW36140, KHKW48170 engine start?
Several factors can prevent your Yazoo/Kees Lawn Mower engine from starting. Here's what to check: * Ensure the blade lever is disengaged. * Confirm the ground speed lever is in neutral. * Verify the fuel valve is open. * Make sure the tank has fuel. * Check and reconnect any loose spark plug wires. * Replace any bad spark plugs. * Replace the bad module, if necessary.
What to do if my Yazoo/Kees KHKW36140, KHKW48170 Lawn Mower won't move or moves slowly?
If your Yazoo/Kees Lawn Mower is having trouble moving, consider these potential causes: * Ensure the pump bypass valves are closed. * Check the pump drive belt; adjust or replace it if it's loose or off. * Inspect the hydraulic system for any failures. * Bleed the hydraulic system to remove any air.
Why does my Yazoo/Kees Lawn Mower pull to the left or right?
If your Yazoo/Kees Lawn Mower veers to one side, here are a few things to investigate: * Check and equalize the tire pressure. * Adjust the motion control linkage. * Avoid soft terrain. * Avoid steep slopes. * Adjust the tracking.
What to do if blades won’t engage on Yazoo/Kees KHKW36140, KHKW48170?
If the blades on your Yazoo/Kees Lawn Mower won't engage, check the following: * Make sure the blade belt is properly attached to the pulleys. * Ensure the linkage is correctly hooked up and adjusted.
Why does my Yazoo/Kees KHKW36140, KHKW48170 have an uneven cut?
An uneven cut with your Yazoo/Kees Lawn Mower can be due to: * Uneven tire pressure: Check and equalize the pressure in all tires. * Bent blades: Straighten or replace any bent blades. * Worn or bent air foil of the blade: Replace or repair the air foil.
What causes a ragged cut with my Yazoo/Kees KHKW36140, KHKW48170 Lawn Mower?
A ragged cut with your Yazoo/Kees Lawn Mower can result from: * Dull blades: Sharpen the blades. * Excessive ground speed: Reduce the ground speed. * Grass accumulation: Clean any grass buildup under the deck.
What to do if my Yazoo/Kees Lawn Mower moves in neutral?
If your Yazoo/Kees Lawn Mower moves while in the neutral position, it could be due to: * Motion control linkage out of adjustment: Adjust the motion control linkage. * Pump arms loose or out of adjustment: Tighten and adjust the pump arms. * Short linkage out of adjustment: Adjust the short linkage.
General| Brand | Yazoo/Kees |
|---|---|
| Model | KHKW36140, KHKW48170 |
| Category | Lawn Mower |
| Language | English |
Mow in daylight, avoid wet grass, use caution on slopes, keep clear of moving parts.
Adjust cutting height using spacers or deck position.
Adjust neutral position and short linkage.
Adjust blade drive belt tension.
Adjust auxiliary blade belt tension.
Check and adjust pump belt tension using idler pulley.
Function and operational checks of safety features.
Familiarize with controls, levers for movement, speed, blades, choke, throttle, tracking.
Key switch, fuel valve, operator presence levers, ground speed lever preparation.
Ensure safety, start engine, adjust throttle.
