Yealink CP860 - Page 33

Getting Started
21
Details of Configuration Parameters:
Parameters
Permitted Values
Default
network.internet_port.type
0 or 2
0
Description:
Configures the Internet (WAN) port type for IPv4 when the IP address mode is
configured as IPv4 or IPv4&IPv6.
0-DHCP
2-Static IP Address
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Basic->IPv4 Config
Phone User Interface:
Menu->Settings->Advanced Settings (Default password: admin)->Network->WAN
Port->IPv4
network.static_dns_enable
0 or 1
0
Description:
Enables or disables the IP phone to use manually configured static IPv4 DNS when
the Internet (WAN) port type for IPv4 is configured as DHCP.
0-Disabled
1-Enabled
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Basic->IPv4 Config->Static DNS
Phone User Interface:
None
network.primary_dns
IPv4 Address
Blank