Customizing Your Phone
17
5. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration
Files on page 11.
You can also configure a static IPv6 address for the IP DECT phone. Before configuring it, make
sure that the IP mode is configured as IPv6 or IPv4&IPv6.
To configure a static IPv6 address via CommPortal phone configurator:
1. Click on Network >IP Setting.
2. Select IPv6or IPv4&IPv6 from the pull-down list of Internet Port Mode(IPv4/IPv6).
3. Select Static IP Address from the pull-down list of Internet Port Type for IPV6.
4. Enter the desired values in the Static IP Address, IPv6 Prefix, Gateway, Primary DNS and
Secondary DNS fields respectively.
5. Click Save changes to accept the change.
6. Perform auto provisioning on the phone to download above configurations. For more
information on how to perform auto provisioning, refer to Downloading Configuration Files
on page 11.
Note
Configuring Static DNS When DHCP is Enabled
Static DNS is not normally required when DHCP is enabled on your phone. In some cases, static
DNS may be needed in your environment. Then you can manually configure static DNS to
ignore DNS obtained by DHCP.
You can configure a static IPv4 DNS for the IP phone. Before configuring it, make sure that the IP
mode is configured as IPv4 or IPv4&IPv6.
To configure Static IPv4 DNS manually via CommPortal phone configurator:
1. Click on Network >IP Setting.
Wrong network settings may result in inaccessibility of your phone and may also have an impact
on your network performance. For more information on these parameters, contact your system
To Next Page
Loading...
