User Guide for the CP920 HD IP Conference Phone
116
The LCD screen prompts “Delete selected paging group?”.
4. Tap the OK soft key to accept the change or the Cancel soft key to cancel.
If you want to delete all paging groups, you can tap the Del All soft key.
You can also configure the phone to use a default codec for sending multicast RTP stream via
web user interface.
To configure a default codec for multicast paging via web user interface:
1. Click on Features->General Information.
2. Select the desired codec from the pull-down list of Multicast Codec.
The default codec is G722.
3. Click Confirm to accept the change.
Note
Receiving RTP Stream
You can configure the phone to receive a Real Time Transport Protocol (RTP) stream from the
pre-configured multicast address(es) and channel(s) without involving SIP signaling. You can
specify up to 31 multicast addresses and channels that the phone listens to on the network.
How the phone handles incoming multicast paging calls depends on Paging Barge and Paging
Priority Active parameters configured via web user interface.
Default codec for multicast paging is configurable via web user interface only.
To Next Page
Loading...
