Getting Started
21
Push Button Configuration (PBC)
To connect to the wireless network using PBC method:
1. Tap Menu ->Settings -> Basic Settings->Wi-Fi.
2. Tap the Switch soft key to select On from the Wi-Fi field.
The IP phone scans the available wireless network in your area.
3. Tap the WPS soft key, and select WPS from the prompt list.
The LCD screen prompts “WPS has been activated, connect in 120s!”.
4. Long tap the WPS key on your gateway/router.
Once WPS setup has completed successfully, the icon appears after the wireless
network name.
Personal Identification Number (PIN)
To connect to the wireless network using PIN method:
1. Tap Menu ->Settings -> Basic Settings->Wi-Fi.
2. Tap the Switch soft key to select On from the Wi-Fi field.
The IP phone scans the available wireless network in your area.
3. Tap the WPS soft key, and then select WPS-PIN from the prompt list.
The LCD screen prompts “Please input below PIN code on your Wi-Fi router and tap OK to
start connecting: xxx”.
4. Log into your gateway/router’s web interface, and configure it to search the clients. For
more information, refer to the documentation from the gateway/router manufacturer.
Once WPS-PIN setup has completed successfully, the gateway/router’s web interface will
prompt success.
Note
Manually Add a Wireless Network
If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results.
In that case, you must manually add a wireless network.
To add a wireless network:
1. Tap Menu ->Settings -> Basic Settings->Wi-Fi.
2. Tap the Switch soft key to select On from the Wi-Fi field.
The IP phone scans the available wireless network in your area.
3. Tap or to high light Known Network(s), and then tap the Add soft key.
4. Use the WLAN settings obtained from your gateway/router to configure this WLAN Profile
on the IP phone. Do the following:
a) If you select None or WEP from the pull-down list of Security Mode:
Contact your gateway/router provider for more information.
To Next Page
Loading...
