Yealink CP935W - Page 7

3
E
N
G
L
I
S
H
Power on/off the CP935W
Power on: Press the home key for 3 seconds or charge the CP935W.
Power off: Press the home key for 10 seconds then tap OK or tap More->Basic->Power
Off->OK on the LCD screen of the CP935W.
Select Mode
When the CP935W is powered on for the first time or reset to factory setting, the screen displays
DECT Mode and Wi-Fi Mode, choose one and click OK. If you want to switch modes, tap More-
>Basic->Phone Mode on the LCD screen of the CP935W.
Registration (DECT Mode)
You can register the CP935W to a W70B Base Station or a W90 Multicell DECT System. Each
CP935W can only be registered to one base station.
When the CP935W LCD screen prompts “Unregistered!”, long press on the base station till
the registration LED indicator ashes. There are two methods to register a new CP935W:
Easy Registration:
1. Tap Reg on the CP935W screen to register quickly.
Normal Registration:
1. Tap More->Basic->Registration->Register on the LCD screen of the CP935W. The CP935W
begins searching the base station.
2. Tap OK after searching a base station successfully (if it’s not the base which you want to regis-
ter to, tap Next to search another base).
3. Enter the base station password (default: 0000), and then tap OK to complete the registration.
Note:
• If the CP935W is registered to the base station successfully, the LCD screen prompts
“Subscribe Succeeded”.
• If the CP935W LCD screen prompts “Searching for Base”, check whether the registration
LED indicator of your base station ashes.
Wireless Network Connection (Wi-Fi Mode)
Please connect to a wireless network before using the CP935W. Follow the steps below:
1. Tap More->Basic->Wi-Fi on the LCD screen of the CP935W.
2. Turn Wi-Fi on. The CP935W will automatically search for available wireless networks in your
area.
3. Select an available wireless network to connect.
4. If the network is secure, enter its password in the Password field, and then tap Connect.