Switching Modes
If required, you can toggle the Wifi and DECT modes, enabling one or the other. To do this:
1. From the main screen press ...More.
2. Press Basic.
3. Press Select Mode and select the desired mode.
4. Press OK to complete the operation.
Note: If the device was previously configured in either mode, those settings will be retained when that
mode is switched to. If not, follow the steps in this article to configure each mode.
Factory Reset
The CP935W can be reset to factory defaults from either DECT mode or WiFi mode.
DECT Mode Reset
1. From the main screen press ...More.
2. Press Basic.
3. Press Registration.
4. Press Delete.
WiFi Mode Reset
First obtain the phone's IP address:
1. From the phone's main screen, press ...More.
2. Press Status.
3. Press Network.
4. Press IPv4 Status, and make a note of the IP address displayed.
Then log into the phone's web interface and perform the reset:
5. In a web browser, navigate to the phone's IP address.
◦ For example: https//:192.168.1.20
6. Log in to the web interface using the appropriate credentials:
◦ User: admin
◦ Password: XXXXXX
▪ The password can be found in 8x8 Admin Console, in the Device Admin Password column of Home
> Devices > View Device Report.
https://support.8x8.com/devices-accessories/phones/yealink/Yealink_CP935W_Phone_DECT_and_WiFi_Configuration
Updated: Fri, 09 Feb 2024 21:08:10 GMT
Powered by
4
To Next Page
Loading...
