Yealink CP960 - Receiving a Voice Message; Leaving Voice Mails; Listening to Voice Mails

Yealink CP960 User Guide
116
Before You Begin
Get the voice mail code from your system administrator.
Procedure
1. Tap to launch Message application.
2. Tap Set Voice Mail.
3. Enter the voice mail code (for example, *4) in the desired account field.
4. Tap
.
Receiving a Voice Message
When receiving a new voice mail, the phone plays a warning tone and the power LED indicator slowly flashes red. A
message of “n New Voice Mail(s)” (“n” indicates the number of unread voice messages) is displayed on the phone
screen.
If the voice mail prompt box disappears, it will not pop up again unless the user receives a new voice mail or the user
re-registers the account that has unread voice mail(s).
Note
Your system administrator can disable the prompt box for new message(s).
Leaving Voice Mails
You can leave a voice mail for other people when they are busy or inconvenient to answer the call. Follow the voice
prompt from the system server to leave a voice mail, and then hang up.
Listening to Voice Mails
When the phone screen prompts that the phone receives a new voice mail, you can tap Connect to dial out the voice
mail access code directly, or tap Exit to close the prompt box when you are not ready to listen to your voice mail.