7
Wireless Content Sharing/Wireless Device-USB Mode
Wireless Content Sharing
1. Connect the WPP20/WPP30 to the USB-A port of the
MeetingBar A20. Waiting for 3 seconds, MeetingBar A20
prompts “Wireless presentation pod pairing successfully”.
2. Connect the WPP20/WPP30 to the PC and press the
Presentation button to share the screen.
Wireless Presentation
Pod
WPP20/WPP30 cannot be used when the endpoint uses a wireless network.
PC
Wireless Device-USB Mode
1. Connect the WPP30 to the USB-A port of the Meeting-
Bar A20. Waiting for 3 seconds, MeetingBar A20 prompts
“Wireless presentation pod pairing successfully”.
2. Connect the WPP20/WPP30 to the PC.
3. On the Yealink Wireless Presentation Pod software, click
BYOD Mode > Press to Share.
Presentation button
Wireless Content
Sharing Video
(Teams)
Wireless Device
USB Mode Video
(Teams)
Wired Content
Sharing Video
(Teams)
Wired Content
Sharing Video
(Zoom)
Wireless Device
USB Mode Video
(Zoom)
Wireless Content
Sharing Video
(Zoom)
Wired Content Sharing/Wired Device-USB Mode
Wired Content Sharing
Ethernet Cable
USB-C Cable with Adapter
PC
USB-C
HDMI
HDMI Cable
Connect VCH51 and MeetingBar A20 with an Ethernet Cable, and connect VCH51 and PC
with a USB-C Cable or HDMI Cable.
• Share screen after the HDMI cable is connected.
• The CTP18 paired with the MeetingBar A20 will prompt whether to enter the BYOD mode,
and click Cancel to share screen after the USB-C Cable is connected.
OR
HDMI
VC Hub
/
Phone
PoE
VCH51
USB-C
Device Mode
Device Mode
Video
1. Do one of the following to select Device Mode:
• When selecting a platform during power-on initialization, select Device Mode.
• Switch platforms after logging in:
Teams: Go to More > Settings > Device Settings > UC Provider, enter the admin password
(0000), and select Device Mode.
Zoom: Go to Settings > General > System Settings > UC Provider, enter the admin password
(0000), and select Device Mode.
2. Refer to steps 1 and 2 of Wireless Device-USB Mode or Wired Device-USB Mode to enter
Device Mode.
To Next Page
Loading...
