| Content Sharing | 28
Resetting the Camera
Procedure
1. On the idle screen, tap Settings > General > System Settings > Others.
2. Tap Reset Camera to reset the camera to factory settings.
Content Sharing
You can present the content while the device is idle or during a meeting.
• Wired Content Sharing
• Using WPP20 Wireless Presentation Pod
Wired Content Sharing
You can connect MeetingBar A20/A30 to the PC via VCH51 for wired content sharing.
Procedure
Do one of the following:
• In idle status, you can see the PC content on the display after connecting MeetingBar A20/A30 to the
PC. If you want to stop presentation, tap Presentation > Desktop to start presentation again.
• In a meeting, you can see the PC content on the display after connecting MeetingBar A20/A30 to the
PC. If you want to stop presentation, tap Share Content > Start Sharing to start presentation again.
Note: For more information on how to connect the VCH51 to the endpoint, refer to Yealink
VCH51 Quick Start Guide.
Using WPP20 Wireless Presentation Pod
Using WPP20 Wireless Presentation Pod for sharing PC content.
Connect WPP20 to MeetingBar A20/A30, when both MeetingBar A20/A30 and CTP18 prompt “Wireless
Presentation Pod Pairing Successfully”, remove WPP20 from the MeetingBar A20/A30. After that, connect
WPP20 to the PC and the PC will pop up the wireless presentation software automatically.
To Next Page
Loading...
