| Network Settings | 32
Parameter Description
IP Address
Assign an IP address to the endpoint/touch panel.
Note: it is configurable only when you disable the DHCP.
Change causes system to restart or reboot.
Subnet Mask
Configure the subnet mask of the endpoint/touch panel.
Note: it is configurable only when you disable the DHCP.
Change causes system to restart or reboot.
Gateway Configure the gateway of the endpoint/touch panel.
Note: it is configurable only when you disable the DHCP.
Change causes system to restart or reboot.
IPv4 Static DNS
Enable or disable DNS feature.
Note: it defaults to disabled.
Change causes system to restart or reboot.
IPv4 Pri DNS
Configure the IP address of the primary DNS server.
Note: in the DHCP environment, you can configure this
parameter only when you enable the IPv4 Static DNS feature.
Change causes system to restart or reboot.
IPv4 Sec DNS
Configure the IP address of the secondary DNS server.
Note: in the DHCP environment, you can configure this
parameter only when you enable the IPv4 Static DNS feature.
Change causes system to restart or reboot.
Connecting to the Wireless Network
You can use the following two methods to connecting MeetingBar A20/A30 and CTP18 to the wireless
network:
• Connecting to an available wireless network
• Connecting to a Hidden Wireless Network
• Connecting to the Wireless Network
• Connecting to a Hidden Wireless Network
Connecting to the Wireless Network
Procedure
1. On the idle screen, tap Settings > General > System Settings > Wi-Fi.
2. Enter the administrator password (default: 0000) and tap Enter.
3. Select Collar Bar/Touch Console.
4. Enable Wi-Fi.
The system will automatically search for available wireless networks in your area.
To Next Page
Loading...
