| Configuring Account Settings | 101
Parameter Description Configuration Method
Port
Configure the port of the custom
server.
Note: the default port number is
0. The value can be any integer
from 0 to 65535.
Web user interface
Endpoint
CTP20
Remember password
Enable or disable the system to
remember the password.
Note: the default value is Off.
If it is set to On, the password
will be filled automatically when
you enter the username next
time.
Endpoint
CTP20
Transport
Specify the transport protocol
for transmitting the SIP
signaling.
The supported protocols are as
follows:
• UDP—it provides the best
transmission for SIP signaling.
• TCP—it provides a reliable
transmission for SIP signaling.
• TLS—it provides a safe
transmission for SIP signaling.
TLS is available only when the
device is registered on a SIP
server that supports TLS.
• DNS-NAPTR—the device
performs the DNS NAPTR
and SRV request to find the
service type and the port if
no server port is given.
Default: TCP.
Web user interface
Server Expires
The registration timeout (in
seconds) of the device.
After the timeout, the device will
send the registration request to
the server again.
Default: 3600 seconds.
Web user interface
Keep Alive Interval
Configure the interval (in
seconds) that the device sends
keep-alive messages to the SIP
server, so that the SIP server can
remain connected to the device.
Default: 30 seconds.
Web user interface
To Next Page
Loading...
