Yealink VC880 - Enabling;Disabling the Clock for the VP59; Setting the Ring Tone for the VP59; Configuring Automatic Sleep Time

| Configuring Basic Settings | 111
2. Configure and save the following settings:
Parameter Description Configuration Method
Time Reminder
Enable or disable the system
to display a clock on the hour
during a call.
Default: On.
Web user interface
3. Configure the time and date.
Enabling/Disabling the Clock for the VP59
After you enable the clock, the time and date are displayed at the center of the Home page. This feature is
only available to VP59.
Procedure
1. Tap Setting > Basic.
2. Enable/Disable Clock.
Setting the Ring Tone for the VP59
You can set the ring tone for VP59, and the ring tone is available to all accounts registered on VP59.
Procedure
1. Tap Setting > Basic > RingTone.
2. Select the desired ring tone.
3. Save the change.
Configuring Automatic Sleep Time
Static images displayed for long periods may lead to monitor burn-in, therefore, you can configure the
automatic sleep time for the device. After the device goes to the sleep mode, “no signal” is displayed on
the monitor.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > General > General Information > Automatic Sleep
Time.
• For your VC880/VC800/VC500/VC200/PVT980/PVT950, on your remote control, go to More >
Setting > Call Feature > Automatic Sleep Time.
• On your CTP20, tap Setting > Basic > Automatic Sleep Time.