Yealink VC880 - Allowing Website Snapshot; Setting the Screen Saver Wait Time

| Configuring Basic Settings | 112
2. Configure and save the following settings:
Parameter Description Configuration Method
Automatic Sleep Time
Configure the inactive time
(minutes) before the system
enters sleep mode.
Note: the default value is 10
minutes.
When you power the system on
and set the setup wizard, the
automatic sleep time feature
is disabled automatically. To
protect the monitor, you should
complete the setup wizard
immediately.
Web user interface
Endpoint
CTP20
Allowing Website Snapshot
You can choose whether to allow the web to show the same content that displayed on your monitor. If you
want to prevent content on your monitor from being viewed remotely, you can disable this feature. This
feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your VCS, go to More > Setting > Basic.
• On your CTP20, tap Setting > Basic.
2. Enable Website Snapshot.
Setting the Screen Saver Wait Time
The screen saver automatically starts when the system has been idle for a period of time you specified. You
can configure the waiting time and after which the monitor starts the screen saver..
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > General > General Information > Screen Saver Wait
Time.
• On your VCS, go to More > Setting > Basic > Screensaver.
On your VP59, tap Setting > Basic > Screensaver.
• On your CTP20, tap Setting > Basic > Screensaver.