Yealink VC880 - Customizing the Local Interface for the System; Hide the IP Address on the Status Bar; Hiding the Time and the Date on the Status Bar

| Configuring Basic Settings | 113
2. Configure and save the following settings:
Parameter Description Configuration Method
Screen Saver Wait Time
Configure the inactive time
(minutes) after which the system
starts the screen saver.
Default: 1 minute.
Web user interface
Endpoint
CTP20
Customizing the Local Interface for the System
You can configure the time after which the system starts screen saver, and customize the screen to show or
hide some information.
• Hide the IP Address on the Status Bar
• Hiding the Time and the Date on the Status Bar
• Hiding the User Interface on Idle Screen
• Showing or Hiding Icons in a Call
Hide the IP Address on the Status Bar
Procedure
1. On your web user interface, go to Setting > General > General Information > Hide IP Address.
2. Configure and save the following settings:
Parameter Description Configuration Method
Hide IP Address
Enable or disable the IP address
displayed on the status bar.
• On—do not display the IP
address.
• Off—display the IP address.
Default: Off.
Web user interface
Hiding the Time and the Date on the Status Bar
You can choose to hide the time and the date on the status bar of your monitor. This feature is not
applicable to VP59.
Procedure
1. On your web user interface, go to Setting > General > General Information > Hide Heading Time.