Yealink VC880 - Custom Tones Formats; Customizing Tones

| Configuring the Audio Settings | 132
Custom Tones Formats
You can customize different tones for the system except for the default tone.
The custom tones formats are as below:
E1,E2,E3,E4,E5,E6,E7,E8 (you can configure up to 8 different tones which are separated by commas)
En=[!][F1][+F2][+F3][+F4] /Duration
Parameter explanation:
• Freq: the frequency of the tone (ranges from 200Hz to 7000 Hz). If it is set to 0Hz, it means the tone is
not played. A tone consists of at most four different frequencies.
• Duration: the duration (in milliseconds) of the dial tone, ranges from 0 to 30000ms.
• An exclamation mark “!” before tones : it means that the tone only rings once.
(for example, !250/200, 0/1000, 200+300/500, 500+1200/800, 600+700+800+1000/2000) means playing
tones once.
Customizing Tones
Procedure
1. On your web user interface, go to Setting > Tones.
2. Configure and save the following settings:
Parameter Description Configuration Method
Select Country Select Custom. Web user interface
Ring Back
Customize the ring-back tone for
the system
Note: the default value is blank.
When it is blank, the American
tones are enabled.
Web user interface
Busy
Customize the busy tone for the
system.
Note: the default value is blank.
When it is blank, the American
tones are enabled.
Web user interface
Call Waiting
Customize the call waiting tone
for the system.
Note: the default value is blank.
When it is blank, the American
tones are enabled.
Web user interface
Auto Answer
Customize the auto answer tone
for the system.
Note: the default value is blank.
When it is blank, the American
tones are enabled.
Web user interface