| Configuring Video Settings | 140
Configuring Change Layout by Content Sharing
The Change Layout by Content Sharing is enabled by default. When you are making a presentation on
the PC, the layout of the image displayed in the device (except for VP59) is changed into 1+N or voice-
activated mode automatically, and the content is enlarged and displayed in the screen.
Procedure
1. On your web user interface, go to Setting > Call Features > Layout.
On your VP59, go to Setting > Call Features.
2. Configure and save the following settings:
Parameter Description Configuration Method
Change Layout by Content
Sharing
Enable or disable Change
Layout by Content Sharing.
Default: On.
Web user interface
Related information
Configuring Content Sharing
Hiding Local Video Image in Equal Layout
If you want to focus on the far sites or the PC content in a call (its video layout is equal layout), you can
choose to hide the local video image.
Procedure
1. On your web user interface, go to Setting > Call Features > Layout.
On your VP59, go to Setting > Call Features.
2. Configure and save the following settings:
Parameter Description Configuration Method
Equal Display Local
Select Off to hide local video
image when the video layout is
equal.
• On—the local video image is
shown.
• Off—the local video image is
hidden.
Default: On.
Web user interface
Configuring Hide Local Video When PIP
In the PIP (Picture-in-Picture) mode, the local video image is always shown at the bottom corner of the
screen. If you enable hide local video when PIP, the local video image is automatically hidden within 5
minutes if there is no operation from the remote control/CTP20/CP960. This feature is not applicable to
VP59.
About this task
Procedure
1. On your web user interface, go to Setting > Call Features > Layout.
To Next Page
Loading...
