Yealink VC880 - Configuring WDR-Manual; Adjusting Display Image of the Camera

| Configuring Camera Settings | 163
Configuring WDR-Manual
WDR-Manual mode is not applicable to VC200.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Exposure.
• On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera > Exposure.
• On your CTP20, tap Setting > Camera > Exposure.
2. Select WDR-Auto from the Exposure Mode drop-down menu.
3. Configure and save the following settings:
Parameter Description Configuration Method
Exposure
Compensation
Configure the value of exposure
compensation.
The exposure compensation is used to
compensate the camera effectively when the
camera is shooting in the backlighting. If the
environment light is dark, you can increase
the compensation value.
Valid value: from -6 to 6. The default value is
0.
Web user interface
Endpoint
CTP20
Exposure Ratio
Configure the value of exposure ratio.
Note: the valid value is 1 to 16. The default
value is 1.
The exposure ratio represents the ratio of
long exposure to short exposure. In a backlit
environment, the bright part uses a short
exposure and the dark part uses a long
exposure.
Web user interface
Endpoint
CTP20
Adjusting Display Image of the Camera
To display high quality video image, you can adjust display mode of the camera or customize the image
display. This feature is not applicable to VP59.
Procedure
1. Do one of the following:
• On your web user interface, go to Setting > Camera > Graphics.
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Camera Setting >
Graphics.
On your VC200, go to More > Setting > Video & Audio > Graphics.
• On your CTP20, tap Setting > Camera > Graphics.