| Configuring Call Settings | 178
Prerequisite Multiparty Resources Inviting the third party
VC500/VC200/ VP59 uses Cloud
account or YMS account with
priority to make a P2P call.
VC880/VC800 system (without an
imported multipoint license) uses
Cloud account or YMS account to
make a P2P call.
Upgrade to be a server VMR
conference first, if so, use the
Endpoint own capacity to initiate
a conference call
VC880/VC800 system (with an
imported multipoint license) uses
any call type (Cloud/YMS/SIP/
H.323/IP) to make a P2P call.
Uses the capacity to initiate a
conference call
PVT980/PVT950 system uses any
call type (Cloud/YMS/SIP/H.323/
IP) to make a P2P call.
Auto
Uses the capacity to initiate a
conference call
Any call type (Cloud/YMS/SIP/
H.323/IP) is used to make a P2P
call
Endpoint Built-in MCU Uses the capacity to initiate a
conference call
Cloud account or YMS account is
used to make a P2P call.
Server VMR Uses server VMR to initiate a
conference call
Note: The system uses its own capacity to initiate a conference call in following situations: one
is dialing a group to initiate a conference call when the system is idle, the other is receiving a call
when the system is during a P2P call.
Procedure
1. On your web user interface, go to Setting > Call Features.
2. Configure and save the following settings:
Parameter Description Configuration Method
Multiparty Resources
Configure the multiparty
resources that the system uses
to initiate a conference call.
• Auto—the available multi-
party resources are used
automatically.
• Endpoint Built-in MCU
• Server VMR
Default: Auto.
Web user interface
To Next Page
Loading...
