Yealink VC880 - Page 185

| Managing the Directory | 185
Adding a Local Contact
You can add 500 local contacts to your system at most.
Procedure
1. Do one of the following:
• On your web user interface, go to Directory > Local Directory > New Contact.
If you import the multipoint license to the device, on your web user interface, click Directory > Local
Directory > New Contact > Local.
• On your VCS, go to Dial > Directory > Local > New Contact.
On your VP59, tap Dial > .
•
On your CTP20, go to Dial > .
If you import the multipoint license to the device, click Add Local Contact.
2. Configure and save the following settings:
Parameter Description Configuration Method
Name Configure the contact name.
Web user interface
Endpoint
CTP20
Number Configure the contact number.
Web user interface
Endpoint
CTP20
Add New Number You can add up to 3 numbers for
the local contact.
Endpoint
CTP20
Bandwidth
Select the desired bandwidth.
The default value is Auto, which
means the system will select
the appropriate bandwidth
automatically.
Note: When you call a local
contact, the call rate that applies
(video call rate or bandwidth)
is the rate with the lower value.
For more information, refer to
Specifying the Video Call Rate .
Web user interface
Endpoint
CTP20
Adding Conference Contacts
You can add 100 conference contacts at most.
About this task
Note: Adding Conference contact is only applicable to VC880/VC800/PVT980/PVT950 system with
a multipoint license. It is not applicable to VC500/VC200/VP59.