Yealink VC880 - Page 213

| Configuring the Security Features | 213
Parameter Description Configuration Method
Control Security Password
Enable or disable an
authentication password
when the control system
tries to connect to the video
conferencing system.
Default: blank.
Note: this parameter is only
available for Control Security
Enabled. If you change this
parameter, the system will
reboot to make the change take
effect.
Web user interface
Baud Rate
Configure the baud rate.
• 2400
• 4800
• 9600
• 19200
• 38400
• 115200
Default: 115200
Note: The baud rate must be
same between the control
system and Yealink video
conferencing system.
Web user interface
Data Bits
Configure the data bits.
• 7
• 8
Default: 8
Note: The data bits must be
same between the control
system and Yealink video
conferencing system.
Web user interface
Parity
Configure the parity.
• None
• Odd
• Even
• Space
Default: Space
Note: The parity must be same
between the control system
and Yealink video conferencing
system.
Web user interface