Yealink VC880 - CEC Monitor Controls; Configuring CEC Monitor Controls

| CEC Monitor Controls | 214
Parameter Description Configuration Method
Stop Bits
Configure the stop bits.
• 1
• 2
Default: 1
Note: The stop bits must be
same between the control
system and Yealink video
conferencing system.
Web user interface
CEC Monitor Controls
Consumer Electronics Control (CEC) is a feature of HDMI designed to allow users to command and control
devices connected through HDMI by using only one remote control. The users can use a remote control to
control all the devices connected by HDMI.
The CEC feature is enabled by default on VC880/VC800/VC500/PVT980/PVT950 video conferencing system.
Ensure that all monitors connected to the system supports and enables the CEC feature. This feature is not
applicable to VC200/VP59.
The following CEC features are available:
• One Touch Play-Use the system remote control to wake up the monitors. All connected CEC-capable
monitors are powered on, and their displays are switched to VCS input.
• System Standby-When the VCS enters sleep mode, all connected CEC-capable monitors are switched
to standby mode for power saving.
Note:
The VCS does not respond to CEC commands issued by a television remote control.
• Configuring CEC Monitor Controls
Configuring CEC Monitor Controls
Procedure
1. On your web user interface, go to Setting > General > General Information.
2. Configure and save the following settings:
Parameter Description Configuration Method
CEC Enable
Enable or disable the CEC
feature.
Default: On.
Web user interface