| Configuring Network Settings | 59
When the system connects to a wireless network, the Wi-Fi icon will display in the status bar. The Wi-Fi
icon indicates the signal strength. The more arcs you see, the stronger the signal strength is.
Note: If you connect the codec to the wireless network via CTP20, make sure that CTP20 is wired to
the codec.
• Connecting to the Wireless Network
• Connecting to a Hidden Wireless Network
Connecting to the Wireless Network
You can manually connect your phone to a wireless network.
Procedure
1. Do one of the following:
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wi-Fi.
On your VC200, go to More > Network > Wi-Fi.
On your VP59, tap Setting > Network & Connection > Wi-Fi.
• On your CTP20, tap Setting > Advanced > Network > Wireless Network.
2. Enable Wi-Fi.
3. If you already enabled wireless AP, select OK to turn it off.
The system will automatically search for available wireless networks in your area.
4. Select the desired wireless network (SSID) and connect to it.
If the network is secure, enter its password in the Password field, and tap Join to Network.
Connecting to a Hidden Wireless Network
Some wireless networks do not broadcast their SSIDs, which makes them unavailable to find. You need to
connect to one of those networks manually.
Procedure
1. Do one of the following:
• On your VCS:
On your VC880/VC800/VC500/PVT980/PVT950, go to More > Setting > Advanced > Wi-Fi.
On your VC200, go to More > Network > Wi-Fi.
On your VP59, tap Setting > Network & Connection > Wi-Fi.
• On your CTP20, tap Setting > Advanced > Network > Wireless Network.
2. Enable Wi-Fi.
3. If you already enabled wireless AP, select OK to turn it off.
The system will automatically search for available wireless networks in your area.
4. Select Other.
5. Enter the name of the wireless network.
6. Select the desired value from the Security Mode drop-down menu.
7. Configure the corresponding parameters.
8. Select Join to Network.
To Next Page
Loading...
