| Configuring Account Settings | 82
Setting H. 323 Account/H.323 IP Call
The H.323 protocol is enabled by default. You can place IP calls via the H.323 protocol. If your network uses
a gatekeeper, you can register an H.323 account for the system, and specify its H.323 name and extension.
This allows others to call you via your H.323 name or the extension instead of the IP address.
• Configuring H.323 Accounts
• H.323 Tunneling
Configuring H.323 Accounts
Procedure
1. Do one of the following:
• On your web user interface, go to Account > H.323.
• On your VCS, go to More > Setting > Advanced > H.323.
On your VP59, tap Setting > Advanced > H.323.
• On your CTP20, tap Setting > Advanced > H.323.
2. Configure and save the following settings:
Parameter Description Configuration Method
H.323 Protocol
Enable or disable the H.323
protocol.
Note: the default value is On.
Only when it is set to On can
the H.323 account be registered.
When it is set to On on both
sites, the devices can call each
other by dialing an IP address
directly.
Web user interface
Endpoint
CTP20
H.323 Account
Enable or disable the H.323
account.
Note: the default value is On.
If it is set to Off, the devices
cannot place or receive calls via
the H.323 protocol.
Web user interface
Endpoint
CTP20
H.323 Name
Configure the device name
that can be identified by the
gatekeepers and gateways.
Note: the default value is blank.
If two devices are registered to
the same gatekeeper, they can
make point-to-point calls by
dialing their H.323 names.
Web user interface
Endpoint
CTP20
To Next Page
Loading...
