Yealink VS800 - Configuring Video Recording

| Configuring Basic Settings | 117
Parameter Description Configuration Method
Screenshot
Enable or disable to capture the
screenshot by using the remote
control.
• On—you can take a
screenshot by the remote
control.
• Off—you cannot take a
screenshot by the remote
control.
Default: On.
Web user interface
•
Taking Screenshots
Related tasks
Configuring USB Storage
Configuring Local Storage
Taking Screenshots
Procedure
Do one of the following:
• On your web user interface, go to Home > Screenshot.
•
On your remote control, if is set to the Screenshot key, press to capture screenshot.
• On your CP960 conference phone, go to More > Screenshot.
Configuring Video Recording
You can record the video.
Before you begin
If you want to record video to USB flash driver, make sure a USB flash drive is connected, and the USB feature is
enabled.
If you want to record the video to the local storage (is only applicable to VC200/VP59), make sure you enable the
local storage.
Procedure
1.
On your web user interface, go to Setting > Video & Audio > USB Config.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Recording
Enable or disable the video recording feature
on the system.
Default: On.
Web user interface