Yealink VS800 - Configuring the Auto Refuse Timeout; Configuring SIP IP Call by Proxy; Configuring the Meeting Room

| Configuring the Meeting Room | 172
Parameter Description Configuration Method
Auto Refuse Timeout (30-240)
Configure the duration time (in
seconds) in the ringing state.
Note: the value is from 30 to
240. Note: the default value is
120. If it is set to 120, the system
will stop ringing if the call is not
answered within 120s.
Web user interface
Configuring SIP IP Call by Proxy
If the account of far site is an URI address (for example, 8000@XX.com), you can use SIP IP address or SIP account
to call the far site.
Procedure
1.
On your web user interface, go to Setting > Call Features > SIP IP Call by Proxy.
2.
Configure and save the following settings:
Parameter Description Configuration Method
SIP IP Call by Proxy
Configure the SIP IP call by
proxy.
• Off—when dialing the URI
of the far site, the system
uses the SIP IP address to
establish a connection.
• On—when dialing the URI
of the far site, the system
uses the SIP account to
establish a connection.
Default: Off.
Web user interface
Configuring the Meeting Room
You can configure the meeting room type, the password and the video layout.
Note:
If you log into the Yealink VC Cloud Management Service, the conference may be managed via the Yealink
VC Cloud Management Service only, you cannot configure it on your system.
•
Conference Types
•
Meeting Password
•
Joining the Meeting
•
Configuring Voice Activation
•
Configuring the View Switching