| Configuring the Meeting Room | 175
Meeting Password
Depending on how a conference call is set up, you might be required to enter a meeting password to join a
conference. You can also require the far site to enter a meeting password to prevent unauthorized participants from
joining conference calls hosted by your system.
If you host a regular mode conference, you need to configure a password for virtual meeting room 1. If you host a
VMR mode conference, you need to configure passwords for virtual meeting room 1 and virtual meeting room 2
respectively. This feature is not applicable to VP59.
•
Configuring Meeting Password
Configuring Meeting Password
Procedure
1.
On your web user interface, go to Setting > Built-in MCU Setting > Conference Setting.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Virtual Meeting Room 1-
>Meeting Password
Enable or disable the system to
configure a password for virtual
meeting room1.
Default: Off.
Web user interface
Virtual Meeting Room 1-
>Meeting Room 1 Password
Configure the password for
virtual meeting room 1.
Valid Value: 1 to 10, default
value: 6.
Web user interface
Virtual Meeting Room 2-
>Meeting Password
Enable or disable the system to
configure a password for virtual
meeting room 2.
Note: the default value is Off.
Only when the meeting room
type is VMR mode can this
parameter be configured.
Web user interface
Virtual Meeting Room 2-
>Meeting Room 2 Password
Configure the password for
virtual meeting room 2.
Valid Value: 1 to 10, default
value: blank.
Only when the meeting room
type is VMR mode can this
parameter be configured.
Web user interface
Related information
Joining the Meeting
Conference Types
To Next Page
Loading...
