Yealink VS800 - Adjusting the Camera Layout During a Call

| Accessories with Your System | 208
Parameter Description Configuration Method
Multi-camera Default Layout/
Camera Layout
Configure the camera layout
during a video call.
• 1+N: the selected camera
is given prominence in
the largest pane, and other
cameras are displayed in
small panes.
• Selected Speaker: the
selected camera is displayed
in the full screen.
• Equal N×N: every camera is
displayed in equal panes.
Default: 1+N.
Web user interface
Adjusting the Camera Layout During a Call
During a call, all video streams captured from the connected cameras are synthesized to one video stream, and then
sent to the far site. You can change the camera layout during a call.
Procedure
1.
Do one of the following:
• When the system is during a call, on your web user interface, go to Home > Camera Layout.
•
When the system is during a call, on your remote control, press or OK key to open Talk Menu, and
select Layout Adjustment > Camera Layout.
• When the system is during a call, on your CP960 conference phone, tap Layout.
• When the system is during a call, on your CTP20, tap Layout > Camera Layout.
2.
Configure and save the following settings:
Parameter Description Configuration Method
Camera Layout
Configure the camera layout
during a video call.
• 1+N: the selected camera
is given prominence in the
largest pane. Other cameras
are displayed in small panes.
• Selected Speaker: the
selected camera is seen in a
large pane.
• Equal N×N: every camera
is given equal prominence in
equal-sized panes.
Default: 1+N.
Web user interface
Endpoint
CP960 Conference Phone
CTP20
3.
If you select 1+N or Selected Speaker as the camera layout, you should choose a camera you want to focus on.