| Configuration Methods | 39
On your VC200, go to More > Network > Wired Network > Advanced Network > Web Server Type.
On your VP59, tap Setting > Advanced > Advanced Network > Web Server Type.
• On your CTP20, tap Setting > Advanced > Advanced Network > Web Server Type.
2.
Configure and save the following settings:
Parameter Description Configuration Method
HTTP
Enable or disable the user to access the web user
interface via the HTTP.
Default: On.
Web user interface
Endpoint
CTP20
HTTP Port
Specify the HTTP port for the user to access the
web user interface.
Valid value: Any integer from 1 to 65535.
Ensure that the configured port is not occupied.
Default: 80
Web user interface
HTTPS
Enable or disable the user to access the web user
interface by using the HTTPS.
Default: On.
Web user interface
Endpoint
CTP20
HTTPS port
Specify the HTTPs port for the user to access the
web user interface.
Valid value: Any integer from 1 to 65535.
Make sure that the configured port is available.
Default: 443
Web user interface
HTTP &
HTTPS
Enable or disable the user to access the web user
interface via the HTTP and HTTPS.
Default: On.
CTP20
VP59
Off Disable the user to access the web user interface
via the HTTP and HTTPS.
Default: Off.
CTP20
VP59
Using VCR11 Remote Control
You can use the real remote control or the virtual remote control to configure and use the system. You can disable the
remote control if it is not needed or not available.
VCR11 Remote Control is not applicable to VP59.
•
Using the Virtual Remote Control
•
Customizing the Key Type
•
Disabling Remote Control Keys
•
Disabling the Remote Control
To Next Page
Loading...
